Mountable Collar, 2pc Clamp, Bore 0.3750, Anod Aluminum, OD 24mm
About The The two-piece design allows this collar to be installed or serviced in-place without the need to remove adjacent components. This two-piece international series mountable shaft collar has a 0.9 standards for maximum holding power
Users can also mount components such as sensors directly to the collar or mount the collar to metal plates. They are supplied with a metric screw allowing users to have an inch bore collar that can be installed with metric tools. Tightly controlled face to bore perpendicularity is maintained (TIR of International series collars have metric outer diameter and width dimensions. Ruland clamp style shaft collars do not mar the shaft, are infinitely adjustable, and have superior holding power when compared to set screw collars. This two-piece international series mountable shaft collar has a 0.3750" bore, 24mm OD, and 9mm width. It has machined flats and tapped holes on the top and bottom of the collar allowing users to stack collars on top of each other when shafting must be perpendicular to each other.
Bearings,V-belts & Power Transmission Equipment,Couplings,Collars,& Adapters,Shaft Collars
Mountable Collar, 2pc Clamp, Bore 0.3750, Anod Aluminum, OD 24mm
Bearings,V-belts & Power Transmission Equipment,Couplings,Collars,& Adapters,Shaft Collars
Specifications of Mountable Collar, 2pc Clamp, Bore 0.3750, Anod Aluminum, OD 24mm | |
|---|---|
| Category | |
| Instock | instock |
